Honda Fury Forums: banner

rear bearing removal

3K views 3 replies 3 participants last post by  crazymanme2 
#1 ·
Well I have my frt. wheel ready to ship to the chromers. Now I have a question on the rear wheel hub.
Do you press that shaft out that goes through the bearings & than use a bearing puller like I used on the frt. bearings ?
I believe that shaft only goes out 1 way.
Any insight will be appreciated.

Craig
 
#2 ·
Take the rear wheel off the bike, the axle and drive plate all come off, then take the wheel to a repair shop with a bearing press and have them take the bearings out. It will only take them 10 mins. Or you could buy a bearing removal tool and take them out yourself with a big hammer.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top