[gary.williams20]

Need some help getting some info on putting on the Kury mini silver bullets on to replace the stock rear signals. I want to put on the hallogen type but the site says the are one wire and grounded to the mount. The Fury has a plastic rear fender so I'm not sure which ones to get. I don't want to get a modul for run turn or leds, hallogen's will work for me.

I saw someone on this forum that put them on the rear replacing the big stock signals. Just looking for some advice before I dish out a $100 bucks. Is the stock signal one wire? Anyone have a part number and or the right size?? 3/8 or 5/16??

Thanks in advance.

 

[Dave Maher]

Need some help getting some info on putting on the Kury mini silver bullets on to replace the stock rear signals. I want to put on the hallogen type but the site says the are one wire and grounded to the mount. The Fury has a plastic rear fender so I'm not sure which ones to get. I don't want to get a modul for run turn or leds, hallogen's will work for me.

I saw someone on this forum that put them on the rear replacing the big stock signals. Just looking for some advice before I dish out a $100 bucks. Is the stock signal one wire? Anyone have a part number and or the right size?? 3/8 or 5/16??

Thanks in advance.

I put them on mine both front and rear. If you purchase the the LED lights you will have to also purchase a load equalizer or your directions will flash rapidly because there is not enough draw. If you go with the halogen as you mentioned you will not need the load equalizer as it has enough draw load to make them flash fine. You will need to run a ground wire up from any ground on the frame to the back of your mounting nut. Great new modification and you will be impressed with the new look. Good Luck! Dave

 

[Clueless]

Need some help getting some info on putting on the Kury mini silver bullets on to replace the stock rear signals. I want to put on the hallogen type but the site says the are one wire and grounded to the mount. The Fury has a plastic rear fender so I'm not sure which ones to get. I don't want to get a modul for run turn or leds, hallogen's will work for me.

I saw someone on this forum that put them on the rear replacing the big stock signals. Just looking for some advice before I dish out a $100 bucks. Is the stock signal one wire? Anyone have a part number and or the right size?? 3/8 or 5/16??

Thanks in advance.

Here is a post that might help http://www.furyforums.com/forum/fury-appearance/1472-rear-silver-bullet-signals.html The stock lights have 2 wires going to them, 1 green, 1 lt blue (rt side) or orange (l side) tie the green wires to the Kury posts, use the other to power the lights. PM me if I can be of any help.

 

[gary.williams20]

Thanks, for the help, once I get them I'll post up what I learned.