[Kennypatterson]

I am looking to replace my BIG stock turn signals but am running into a problems finding alternatives other than RAW's assembly (which I'm still considering). I have the Kuryakyn Small Silver Bullets on my other bike but they don't make the fork clamps in a 45 mm which our forks are. I looked into the LED wrap arounds and no luck there either. Has anyone replaced theirs and if so what did you use?

 

[Hoseman581]

These bikes are so new to the market that there are not a lot of choices right now. The rear LED light from RAW does appear very nice and I am not sure how I feel about the front ones yet. But they seem to be the only vendor that has come across this website that has those products specifically for our bike! Good luck!

 

[Cosgrc]

I sent Kuryakyn an email this morning because I habe been wondering the seem thing. I figured it was just a matter of time. Below is my response from Kuryakyn.

At this time we do not have anything scheduled for 45mm fork clamps. However we are constantly looking to expand our inventory. Please check back at a later time for updates. Thanks for your interest in our products. Have a great day!

 

[chopped]

Currently, the only options I have found are replacing the bezels and lenses or going with the RAW setup.

 

[Clueless]

Or you could do this

 

[cephyus9]

There is stuff out there. I did some nice billet wrap arounds with some mods so they would fit properly. And flexible LED Array on the back for now until i get tired of it or someone has an easy kit to get rid of the plate etc... PM me if you want the links. It can all be done in a day with patience.

 

[daRe]

^links please?

 

[DeadSpider]

^links please?

I think this is the correct one Wrap-Around LED Billet Fork Clamps

 

[cephyus9]

yep. wasnt sure if i should post cause the arent a sponsored vendor

and they dont have the specific size for the forks, you have to get the larger size, get a longer set screw and some sort of material as a buffer. Which I would have prefered anyway so its not metal on metal.

 

[RAWONE]

We do these Fat Fork Tubes that come with or without strips of LED's to use as Running / Turn signals. We have not done them for the Fury, but were considering it. With this suspension, they would only be for between the trees.
Comments?

 

[Adirondack_Furian]

We do these Fat Fork Tubes that come with or without strips of LED's to use as Running / Turn signals. We have not done them for the Fury, but were considering it. With this suspension, they would only be for between the trees.
Comments?

Build them. I will buy them, no doubt about it. I would prefer that they be set up in such a way that they would act only as turn signals and not as running lights.

 

[Kennypatterson]

Very cool RAW! What type of price do they go for on the other bikes?

 

[Kennypatterson]

There is stuff out there. I did some nice billet wrap arounds with some mods so they would fit properly. And flexible LED Array on the back for now until i get tired of it or someone has an easy kit to get rid of the plate etc... PM me if you want the links. It can all be done in a day with patience.

What MM did you buy and what type of material did you use for a buffer?

They look good.