[gary.williams20]

Anyone have any ideas on how to remove after market grips? I replaced my stock grips with Kury flames but want to change them out to a diamond style. Was worried that since I glued the shit out of them I may break something trying to remove them.

 

[Snuffdog76]

ugh, no clue bud outside of letting a shop do it

 

[FuriousWrath]

I can't remember what kury. grips look like or if the material is soft enough inside, but I've had luck with this method on other grips.
I take a air compressor nozzle and put a needle attachment like you would use to fill up a basketball. Then slide the needle in to the grip from the inside or thumb-side of the grip and blow air. It will create pockets separating the grip from the bar. This also is good when removing stock rubber grips. I don't know if this will help your situation but worth a shot. Good Luck!

 

[mental]

I think CLUELESS might have an answer, Good Luck!

 

[RC51Pilot]

Contact cleaner - spray it under the grip and it'll remove the glue - also lubes it so it slides off easy.

 

[gary.williams20]

Thanks all