Honda Fury Forums: banner

1 - 6 of 6 Posts

·
Registered
Joined
·
1,480 Posts
Discussion Starter #1 (Edited)
I'm a little on the short side so I moved the seat forward 1/2 inch, cut off the front section over the tank so the seat butts into the tank, cut the rubber stands on the bottom of the seat in half and this is what I came up with. I'll still have to make some modifications to the pan once I do the T-mod so the back of the pan will sit against the rear fender but like everything else it's a work in progress. I'm hoping I attached the pictures right?
 

·
Premium Member
Joined
·
4,152 Posts
Looks good!!! The T-mod doesn't even pull the seat back 1/4" so no probs there. no pan mods required.
 

·
Premium Member
Joined
·
4,751 Posts
I agree, it does look good, good job on modding the seat, can't even see any wrinkles in the front where you modded it.
 

·
Premium Member
Joined
·
3,454 Posts
that is a nice looking fit--actually flows better than oem. good job!
 
1 - 6 of 6 Posts
Top