Honda Fury Forums: banner

side mount license plate

4268 Views 7 Replies 6 Participants Last post by  Accutronix Billet
Does anyone know how or what do do with cutting the oem license plate bracket, to install a side mount instaed
1 - 8 of 8 Posts
what a coincidence. i'm installing an accutronix one right now. i took the whole taillight assembly apart (may not need to, but i am just cautious). i am just curious where everyone ran the wire. did you run it through the shaftdrive? that's the only 'clean' place that i know of...

never mind, i found a link that tells all :)
I used a dremmel with a thin cut off disk. Then trim down the plastic with a blade.
i just taped off a straight line around the taillight (it'll look like predators when done) and used a hacksaw, so i could take my time. just need to trim the metal support and wire it, and slap it all back together. i'll finish it tonight
Let us know if you like your new plate mount and if the install was simple.
2
yep, i think i like it! it took a few hours, but i was also piddling around with other stuff (2 yr old). fairly easy, just time consuming to get it right.

Attachments

See less See more
i took a small air saw and zipped mine off.15 minuts.

Attachments

See less See more
Yup!

Does anyone know how or what do do with cutting the oem license plate bracket, to install a side mount instaed
Do a search for "Montana Redneck License Plate fix" & you will see what I did. Hope this helps.
1 - 8 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top