Honda Fury Forums: banner
1 - 1 of 1 Posts

·
Premium Member
Joined
·
1,967 Posts
Like any side mounted license plate, you need to tie into the factory license plate wiring. I chose to heat shrink the wires, run them in a plastic flex tubing under the fender to use the factory connector in the rear fender.
To diguise the wires coming from the license plate, get some sticky wire holders (clips) to place under the rear drive swing arm.
(I got a pack of ten from ACE hardware)
This will allow to hold the wires up and out of the way.
Hope that helps
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top