i put a set of kuryakyn LED silver bullets on and i had to use the load equalizer. i know without it they flashed quickly. dunno if that helps
Go here:This question goes out to those guys that installed the RAW front and rear LED's.
I was wondering for those that did not install the 'dual load equalizer' if your front and rear lights both blink at the same speed?? I assume they will blink at the same speed either slower or faster with or without the equalizer.
I appreciate your input fellas.
I chose not to install the load equalizer with the RAW tail light. The flasher rate is fast. I wanted it that way. It gets attention..Hmm, that is not quite what I am looking for.
I am just wondering that if you install (or don't install) the load equalizer in the back like the raw design instructions tell you that it affects how the front signals blink as well. I assume it does so that the front and back blink at the same speed.
Hey thanks! It was just good to know. I am pretty sure I am going to install without the load equalizer. Anything to attract more attention to myselfit's about twice per second or so