Honda Fury Forums: banner

1 - 7 of 7 Posts

·
Registered
Joined
·
829 Posts
Discussion Starter #1
I replaced the rear turn signals with some bullet turn signals, but the dealership says they cannot find clamps that will fit to replace the front turn signals. Anyone have suggestions on where I can find clamps that will fit or other options?
 

·
Registered
Joined
·
427 Posts
My dealership put these on the blue fury they got in and I think they look good.
Küryakyn
 

·
Registered
Joined
·
829 Posts
Discussion Starter #3
What size?

What size did they use? Do you have the exact link to what they used because Kuryaykn said they did not have the right size clamp.
 

·
Registered
Joined
·
427 Posts
Im not sure but they should be the same as the 1300VTV, don tell me they dont have those.
 

·
Registered
Joined
·
829 Posts
Discussion Starter #5 (Edited)
No p-clams to fit

They installed the rear turn signals. They look similar to yours. I love thme, but they said they could not find p-clams to fit the forks to install the front turn signals. The forks are 45mm and Kuryakyn says they don't have p-clams that will fit. Suggestions? Did they get the front turn signals on yours?
 

·
Registered
Joined
·
30 Posts
The only other bike that has the 45mm front forks that I have found is the VTX 1800c and they are a 45mm inverted fork.
 

·
Registered
Joined
·
829 Posts
Discussion Starter #7
Thanks, but just removed them!

Thanks all, but I went ahead and just removed the front turn signals instead. I found out you don't need them in Texas. Bike looks much better now without them.
 
1 - 7 of 7 Posts
Top